Step 1. Click replace tool from the tool bar.

Step 2. Click on the piece of hardware you would like to replace.

Step 3. If you want to replace all instances of the hardware you have selected, click on the drop down box, located on the left hand side of the screen above the green tick and red cross box. This drop down box allows you to select large amounts of similar hardware simultaneously. For example, if you selected a corner, the drop down box will give you the following options:

Replace all xxxxxx ( name of selected hardware): All hardware of

the same model name to be replaced.

Replace all corners: All corners on the case to be replaced.

Replace all Lid corners: All corners on the lid to be replaced.

Replace all Base corners: All corners on the base to be replaced.

Step 4. Once you have made your selection, Press the Green tick to confirm the selection or the Red cross to cancel the operation.

Step 5. You can then select from the library the corner you want to replace the selected corners with.

Step 6. The software will show the new corners in location and will show up as green if they fit and do not clash with anything, if they do clash with other hardware then they will show up as red.

Step 7. If everything is green you can click the Green tick to confirm the operation or the Red cross to cancel the operation.